Installation, Step 1: unpack the camera – ACTi I93 User Manual
Page 13
Hardware Manual
Installation
Step 1: Unpack the Camera
NOTE:
To avoid scratches or leaving fingerprints on the dome cover, it is recommended to retain
the plastic covering the dome cover until the camera is completely installed. However, the plastic
has been removed on the pictures in this documentation to show clarity of the procedures being
described.
1.
Loosen the four (4) screws using the hex screwdriver included in the camera package.
2.
Carefully lift the camera cover and place it aside.
NOTE:
The cover is attached to the camera by a metallic wire strap; do not abruptly lift the
cover.
This manual is related to the following products:
- I94 I95 I96 I910 KCM-8211 I96 2 MP Extreme WDR Day & Night HPoE Outdoor Speed Dome PTZ IP Camera with 30x Lens I915 2MP Outdoor PTZ Network Dome Camera with Night Vision & Heater B928 5MP Outdoor PTZ Network Speed Dome Camera with Night Vision B915 3MP Outdoor PTZ Network Speed Dome Camera with Night Vision