10base-t (lan), 10base-t connector, 10base-t (lan) -33 – Hakko MONITOUCH V7 series User Manual
Page 50: 10base-t connector -33, Caution
1
13. 10BASE-T (LAN)
1-33
Har
13. 10BASE-T (LAN)
The connector for 10BASE-T is provided as standard on V7i (high-performance). To
connect Ethernet with V7 (standard), use the communication unit “CU-03.” If CU-03 is
attached to V7i, it has priority over the built-in 10BASE-T; 10BASE-T cannot be used.
10BASE-T Connector
• Use this connector for Ethernet connection.
- For V708i:
- For V710i/V712i:
• The LAN (10BASE-T) pins correspond to signals as given below.
Side View
Bottom View
CAUTION
MJ1/2 and LAN connector are 8-pin modular jacks. Check the name plate and
insert the connector in the correct position.
LAN
Pin No.
Signal Name
Contents
1
TX+
Ethernet send signal (+)
2
TX-
Ethernet send signal (
−)
3
RX+
Ethernet receive signal (+)
4
NC
Not used
5
NC
Not used
6
RX
−
Ethernet receive signal (
−)
7
NC
Not used
8
NC
Not used
1 2 3 4 5 6 7 8