Hakko MONITOUCH V7 series - Manual (Page 194)

4
1. Ethernet 4-43
Netw
or
k C
o
mm
uni
ca
tio
n
s
Get Error Contents
int HKEtn_GetLastError()
• Error codes and solutions
Code Contents Solution
−1
Undefined command (receive timeout) Check the command.
−2
Undefined IP address Check the IP address.
−3
Target station busy Reduce the frequency of communications.
−4
Illegal packet bytes Check response processing at the target
station.
−5
Packet bytes exceed the maximum
number. Reduce the send packet size.
−6
Local mode error Check that the target station is in the RUN
mode.
−7
Preparing for communications Start communications when the target
station is ready.
−8
Communication failure – Cannot access Check the target station.
−9
Cannot process due to short memory Check the memory space at the target
station.
−10
Illegal received data Check the command.
−20
Socket initialization error Check parameters for initialization.
−50
Requested packet byte exceeds the
maximum number. Reduce the requested size.
−51
Address error Check the requested memory type.
−52
Communication failure – Cannot access Check the target station.
−54
Write protected Check write-protection of the card.
−55
Cannot process due to short memory Check the memory space at the target
station.
−56
Sampling buffer error Check the command.
−100 Processing another command
Continue retrying.
−101 Command control – Buffer over Reduce the frequency of communications.
−120 Communications aborted by the user
Communications are forcedly aborted.
−121 Received during command processing
Reduce the frequency of communications.