Wavetronix SmartSensor HD (101-0415) - User Guide - Manual (Page 82)

Appendix
In this chapter
˽ Appendix A - 10-pin Connector
˽ Appendix B - 26-pin Connector
˽ Appendix C - Cable Lengths
˽ Appendix D - Direct Serial Connections
˽ Appendix E - Signaling Delays
Appendix A - 10-pin Connector
Many newer SmartSensor HD installations have a 10-pin connector for attaching the cable;
this connector is used exclusively with the 8-conductor cable. This cable is composed of
eight conductors plus a drain wire, all surrounded by a shield. See Figure A.1 for a diagram
of the 8-conductor cable’s 10-pin socket assignment. The codes listed in the diagram are to
be used to solder wires into the back of the plug where the letters represent the individual
solder cups.