Applying silicon dielectric compound – Wavetronix SmartSensor HD (101-0415) - User Guide User Manual
Page 17
16
CHAPTER 1 • INSTALLING THE SMARTSENSOR HD
Note
The side-to-side alignment will eventually be fine-tuned for better accuracy using
SmartSensor Manager HD (SSMHD). That step will be addressed in Chapter 6, after
SSMHD has been installed.
Side-to-side alignment should
be perpendicular
Figure 1.5 – Side-to-side Positioning
Applying Silicon Dielectric Compound
Use the following steps to correctly apply the silicon dielectric compound:
1 Tear the tab off of the tube of silicon dielectric compound.
2 Squeeze about 25% of the silicon into the connector at the base of the SmartSensor HD
(see Figure 1.6). Be sure to wipe off any excess compound.
Figure 1.6 – Applying Silicon Dielectric Compound