Verilink DCSU 2911 (880-502647-001) Product Manual - Manual (Page 51)

DCSU 2911 E1 Craft Interface
Verilink DCSU 2911 User Manual 4-5
Table 4-3
Node Administration Parameters
Command Description Options
T Set Time: Use this option to set the time for your node.
You must set the time zone before you set the time.
Time: hh:mm:ss
D Set Date: Use this option to set the date for your node. Enter the date
(mm/dd/yy). Enter the day of the week (1=Sunday).
Date: mm/dd/yy
Z Set Time Zone: Use this option to set the time zone for your node.
Time can be specified for any of four time zones: Eastern Standard
Time (EST), Central Standard Time (CST), Mountain Standard Time
(MST), or Pacific Standard Time (PST).
To set the time zone as Greenwich Mean Time) select Local Time.
To use the custom option, enter positive or negative offset in hours
from Greenwich Mean Time. Then enter an abbreviation for the time
zone (6 characters maximum).
Choose either Yes or No for the “daytime savings” option.
Time zone:
1) local time
2) EST
3) CST
4) MST
5) PST
6) custom
Daylight Savings
Time:
Yes or No
A Set Node Address: This option to indicate the ACP node address (the
node address follows the same syntax conventions as the network IP
address, but they are not the same). If you change the default
address, make sure the first byte is in the range of 0-127. All other
bytes can be values from 0 to 255. However, 0.0.0.0 is not a
supported address.
Node address such
as:
WWW.XXX.YYY.ZZZ
where WWW must
be in the range of
0—127.
R Reset Card: This option reboots the card. Yes to Reset
P Change Password: Use this option to assign a new password for a
privileged or unprivileged user.
-- PASSWORD MENU --
P) Privileged Password U) Unprivileged Password
X) main menu
[1,8] DCSU 2911 > p
Enter New Privileged Password:
Enter New Privileged Password again:
Privileged Password—Enter the new password and confirm it by
reentering it. Use this option to view and change all the DCSU
information, including changing equipment configurations.
Unprivileged Password—Enter the new password and confirm it by
reentering it. With this password you can only view the information
about the DCSU module, you cannot alter any configuration
information associated with this module.
Q Query Firmware: Use this option to display the firmware versions and
the status of the firmware versions for the A or B partitions.
I Change Site Name: Use this option to specify the site name for the
DCSU. All reports will contain this information and—in case of
problems—will help identify the problem location.
Site name:
Maximum of 20
characters
O Switch Over Permanent: Use this option to indicate partition A or B
and its corresponding firmware version when rebooting the module.
Assign a permanent partition to boot from in case of power failure.
Before choosing a partition, ensure that a firmware version exists on
both partitions using the Query Firmware option above.
1) A
2) B
Y Switchover Once: Use this option for testing new firmware versions.
Use this option to change from partition A to B or vice versa. Though
you can use this option for diagnostics, indicate a permanent
partition to boot from in case of a power failure.
1) A
2) B