Verilink DCSU 2911 (880-502647-001) Product Manual - Manual (Page 16)

DCSU 2911 Quick Set-Up
2-2 Verilink DCSU 2911 User Manual
Connect to Craft
Port
Connect the modular (RJ-11) end of the Craft cable to the port
labeled L
OCAL on the NCM front panel. Connect the other end of the
Craft cable to your PC or terminal. If your PC has a DB-9 COM port
connector, use a standard PC-AT serial cable to complete the
connection.
Terminal
Parameters
Set your terminal, or terminal program, to
• 19.2 kbit/s
• 8 data bits
• no parity
• one stop bit
• no flow control
NOTE: For the most effective and efficient set-up, have all required
planning data such as your intended use, network (telco) provider
specifications, channel and line requirements, circuit
configurations, and other important information handy. For your
convenience, worksheets are provided in the manual, AS2000: The
Basics, Chapter 2—Site Planning .
Logging On 1. Press E NTER to display the pSH+> prompt and type “craft”.
2. Press E NTER to display the NCM Main Menu.
If the NCM Main Menu display ( Figure 2-2) shows the DCSU in the
proper shelf/slot position, continue with the configuration tasks.
The default password for the NCM gives the user Access Level 2
permissions. For a higher access level, see the NCM 2000 User
Manual.
Bus
Compatibility
If there is no indication of the DCSU on the “shelf map” on the NCM
Main Menu, the modules may be assigned to different busses on
the shelf midplane.
NCMs are sent out with the C bus as the default bus. Other modules
are sent out with the A bus as a default.
Assign the DCSU to the same bus as the NCM. To assign the bus,
use the DCSU’s Craft port:
1. Connect the Craft cable to the Local port on the DCSU module.
2. At the YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD? prompt, press E
NTER . The DCSU Main
Menu displays.