Thinklogical Velocitykvm T-4200 Chassis Manual - Manual (Page 11)

®
T-4200 Chassis, Rev. A
11 September 2011
Display Modifiable Description
*DDC
DDC PROM Emula. Mode YES Options are Dynamic, Static and Passthru.
In Dynamic mode, the DDC of the monitor connected to the
RX is read and stored on the TX. The CPU is informed of a
change in DDC and the monitor is read. This is useful when
the CPU can be turned on without a connection to the RX.
Static mode is used to maintain the current DDC regardless
of monitor changes at the RX.
Passthru mode makes the DDC pins look like direct
connections between the TX and RX, allowing the computer
to talk directly to the monitor.
Load Default DDC YES Loads the default DDC stored in the application which allows
1024x768. This puts the TX into static mode.
Acquire DDC YES Gets the DDC table of the unit attached, stores the
information and puts the TX in static mode.
Force DDC Mode YES Used to force the DDC of a monitor to appear as either digital
or analog. Since Velocity products can convert between
analog and digital, sometimes the DDC has to be modified to
match the method of connecting the TX to CPU.
RECEIVER:
Display Modifiable Description
*System
LS Connected
NO An indication of the fiber status from the TX to RX.
Tx Ctrl Name TX Only Name entered on TX unit is displayed on RX unit.
KM Device NO Revision of the Velocity portion that plugs into CPU.
KM Remote Host NO Revision of the Velocity KM Host on the RX unit.
KM Local Host NO Revision of the Velocity KM Host on the TX unit.
TX Control NO Revision of the TX unit laser and front panel control.
RX Control NO Revision of the RX unit laser and front panel control.
FPGA Version NO Revision of the FPGA used for video generation.
Serial Number NO 2 digits each for DDMMYY and 2 or 3 unique digits
Debug Values YES Factory Use.
SFP Loss of Signal NO Indicates loss of SFP signal
Temp in Celsius NO IN=PCB temp (max=70) EX=FPGA temp (max=85)
KMASS Card ID NO
Video Card ID NO
USB 2.0 Card ID NO