Fcc part 68, National electrical code – Teo E911 Response System Installation User Manual
Page 88
Teo E911 Response Server 9145 Installation Instructions
Page 88
13-280133 Rev. C
F
F
C
C
C
C
P
P
a
a
r
r
t
t
6
6
8
8
This unit is registered with the FCC and complies with the part 68 of the FCC regulations.
The following information is provided as part of that compliance.
On the rear panel of this unit is a label that contains the FCC registration number and the
ringer equivalence number (REN) for this equipment. You must, upon request, furnish this
information to your telephone company.
This unit must be installed by telephone installation personnel.
If this unit is installed and trouble occurs, it must be disconnected, and reinstalled only
after the problem has been corrected.
If this unit appears to be causing a problem with the telephone network and it is not
removed, the Telephone Company may discontinue service temporarily. If possible they
will give advance notice. However, If advance notice is not practical, notifications will be
made as soon as possible. The Telephone Company will allow time to correct the situation.
They will also provide information on your rights to file a complaint with the FCC.
The Telephone Company may make changes to its equipment or procedures that could
affect the proper functioning of this unit. If they do, you will be notified in advance to give
you an opportunity to maintain uninterrupted service.
Repair work on this unit must be done by the manufacturer, Teo Technologies.
When installing this unit, and ordering ISDN-PRI circuit facilities with AMI line coding from
the Telephone Company specify:
Service Order Code: 6.0Y
Facility Interface Code: 04DU9.1KN
USOC Jack No.: RJ48C
When installing this unit, and ordering ISDN-PRI circuit facilities with B8ZS line coding
from the Telephone Company specify:
Service Order Code: 6.0Y
Facility Interface Code: 04DU9.1SN
USOC JACK No.: RJ48C
Additional Information that may be required:
FCC Reg. No.: US:
{pending}
N
N
a
a
t
t
i
i
o
o
n
n
a
a
l
l
E
E
l
l
e
e
c
c
t
t
r
r
i
i
c
c
a
a
l
l
C
C
o
o
d
d
e
e
This equipment shall be installed only in restricted access areas in accordance with Article
800 of the National Electrical Code ANSI/NFPA No. 70 1999 and any local codes as
required. All external wiring should follow current National Electrical Code requirements.