Teac CD-BT1 - Manual (Page 15)

14
— TASCAM CD-BT1 TASCAM CD-BT1 —
15
Using effects
How effects work
ere are five slots numbered from
1 through 5 where you can store your
own effect settings
ffects are created from the  preset
effects available hen a slot is se
lected if a preset effect is recalled and
edited that slot is automatically filled
with the edited effect
Storing your own effect settings
in a slot
ress the EFFECT key to select the slot
 1 through 5  as shown on the display
ress and hold the EFFECT key or press
the LCD MENU key until EFFECT ap
pears on the display
or
se the 6 key to turn the effect ON 
ress ENTER  and then select the
preset effect  00 through 15  with the
6 and fl keys
NOTE
If there were any settings in the selected slot
to start with, they will be overwritten when
you recall a library entry.
ress ENTER once more to start edit
ing the parameters with the the 6 and
fl keys see the table for details of these
parameters
e last parameter is always
LVL the
output level from the effect unit  0 to
64  is is only available when the ef
fect is active and is bypassed with the
effect off
et the level and then press the
DISPLAY/ESC key to exit the effect
settings e effect settings you have
made are automatically stored in the
slot you first chose
Recalling an effect with your
settings
hen you have stored the effect set
tings in a slot as described above you
can recall them simply pressing the
EFFECT key to select the appropriate
slot you should also make sure that the
effect is switched on
TIP
If you have a footswitch connected and the
FOOT menu item is set to EFF, you can step
through the slots by pressing the footswitch.