Teac CD-BT1 - Manual (Page 12)

12
— TASCAM CD-BT1 TASCAM CD-BT1 —
13
Using the CD player
e s  player works
in much the same way as other 
players with a few minor differences
and special features as explained on
this page
oad s label side up shiny side
down in the  pen and
close the player door by hand by lifting
the door tab marked PULL 
NOTE
The CD-BT1 cannot play unfinalized CD-R/
RW discs. In addition, some finalized CD-R/
RW discs may be unplayable on the CD-BT1.
Playback
ress the playpause  Á/π  key to
start playback and to pause playback
ress the stop key 
ª  to stop play
back
Display
se the DISPLAY/ESC key to change
the display between track elapsed
time track remaining time and total
remaining time you cannot do this in
menu mode
Skipping between tracks
se the two skipsearch keys marked
as Ô? and ¯?  to move
back and forward a track at a time by
pressing and releasing the appropriate
key
Searching within tracks
se the skipsearch keys to search
within the disc by pressing and hold
ing the appropriate key
The CUE key
e CUE key is a special feature of the
 hen you press this key the
playback position returns to the last
point where playback started
hat happens next depends on the
CUE
menu item setting in the MENU menu
f this is set to CUE  playback is paused
at the cue point but if it is set to FLS 
playback restarts from the cue point
TIP
With a footswitch connected, you can use
this instead of the
CUE key for hands-free
operation (set the FOOT menu item to CUE).
Looping (track)
sing the PLAY menu item set SGL sin
gle play ress the LOOP key so that
you see LOOP 1 on the display bottom
left e current track will repeat
Looping (disc)
sing the PLAY menu item set ALL play
all the disc ress the LOOP key so
that you see LOOP alone on the display
bottom left e whole disc will
repeat
Looping (I/O points)
se the I/O key to set the start in
point of the loop then use the key to
set the end out point e section be
tween the points will repeat seamlessly
ressing the
I/O key again clears the
loop points and cancels loop mode
ith these points set 
I-O shown on the
display you can restart the  loop
mode if it has been canceled using the
LOOP key