Teac US-322 User Manual

Page 23

TASCAM US-322/366

5 – Using the US-322/366 Mixer Panel

Exciter

This effect emphasizes high-frequency harmonics to add

clarity and sparkle while maintaining the original sound.

FREQUENCY: 1 to 4 kHz (default: 2.00 kHz)

Sets the frequency above which harmonics are empha-

sized.
DEPTH: 1 to 100 (default: 75)

Sets the amount that harmonics are emphasized. The

higher the value, the more they are emphasized.

Three-band parametric equalizer

This can be used to increase or decrease the levels of

specific frequency ranges. This can be used to enhance

the sound of individual instruments, to adjust the balance

of a wide frequency range and to cut specific unwanted

frequencies, for example.

The frequency response is shown even when the equalizer

is off. The equalizer has a high-shelf HIGH band, a low-shelf

LOW band and a peaking (bell-shaped) MID band.

HIGH GAIN: −12 to 12 dB (default: 0 dB)

Sets the amount the level is increased or decreased for

the high shelf.
HIGH FREQ: 1.7 to 18 kHz (default: 10 kHz)

Sets the cutoff frequency of the high self.
Mid GAIN: −12 to 12 dB (default: 0 dB)

Sets the amount the level is increased or decreased for

the mid peak.
Mid FREQ: 32 Hz to 18 kHz (default: 1.0 kHz)

Sets the center frequency of the peak.
Mid Q: 0.25 to 16 (default: 0.5)

Sets the acuteness of the peak. The higher the value

the narrower it becomes, making it effect a narrower

frequency band. The lower the value, the wider it

becomes, making it effect a broader frequency band.
Low GAIN: −12 to 12 dB (default: 0 dB)

Sets the amount the level is increased or decreased for

the low shelf.
Low FREQ: 32 Hz to 1.6 kHz (default: 100 Hz)

Sets the cutoff frequency of the low shelf.

Send effect

Reverb

This effect adds reverberations to the original sound by

adding multiple sounds delayed at various times with

damping over time that produces a sound that is as natural

as possible. Reverberations like those of a hall, live-music

club or a studio, for example, can be generated.

ROOM TYPE: HALL, ROOM, LIVE, STUDIO, PLATE

Select the type of reverb.
Depending on the setting, the density and level of the

reverb sound changes.
PRE DELAY: 0 to 250 ms (default: 90 ms)

Set the amount of time until the first reverberations. The

larger the value, the larger the reverberations make the

room sound.
REVERB TIME: 0.1 to 10 sec (default: 2.7 sec)

Set the amount of time that the reverberations continue.

The larger the value, the longer they continue.