Teac DR-60DMKII - Manual (Page 23)

TASCAM DR-60DMKII
23
Message
The following is a list of the pop-up messages that might appear on the
DR-60DMKII under certain conditions.
Refer to this list if one of these pop-up messages appears and you want to check
the meaning or determine a proper response.
Message Meaning and response
Battery Empty The batteries are almost out of power. Replace the batteries.
Can't Divide
The position selected for divide is not suitable (too close to the
beginning or end of a file).
Card Error The SD card could not be handled properly. Change the card.
Card Full
The SD card has no remaining capacity. Erase unnecessary files
or move them to a computer to make open space.
Dup File Name
The DIVIDE function would cause the file name to be the
same as that of an existing file in the same folder. The DIVIDE
function adds “a” or “b” to the end of the file name. Before
choosing the DIVIDE function, connect the unit to a computer
and edit the file name.
File Full
The total number of folders and files exceeds 5000. Erase
unnecessary folders and files or move them to a computer.
File Name ERR
The DIVIDE function would cause the file name to exceed 200
characters. The DIVIDE function adds “a” or “b” to the end of
the file name. Before choosing the DIVIDE function, connect
the unit to a computer and edit the file name to less than 198
characters.
File Not Found
The file either cannot be found or could be damaged. Check
the file using a computer.
File Not Found
Make Sys File
The system file is missing. This unit requires a system file for
operation. When this message appears, press the DATA dial to
automatically create a system file.
File Protected The file is read only and cannot be erased.
Message Meaning and response
Format Error
Format CARD
The SD card might not be formatted properly or its might be
broken. This message also appears if the card was formatted
using a computer connected by USB and if an unformatted
card is inserted in the unit.
Always use the DR-60DMKII to format cards to be used with it.
Change the card or press the DATA dial while this message is
being shown to format the card.
Formatting an SD card will erase all the data on it.
Invalid Card
Change Card
Something might be wrong with the SD card. Change the SD
card.
Invalid SysFile
Make Sys File
The system file required to operate this unit is invalid. When
this message appears, press the DATA dial to automatically
create a system file.
Layer too Deep Folders can be created down to two layers. You cannot create
a new folder inside the current folder.
Max File Size The file is larger than the designated size
MBR Error Init
CARD
The SD card might not be formatted properly or its might be
broken. Change the card or press the DATA dial while this
message is being shown to format the card.
Formatting an SD card will erase all the data on it.
No Audio File There is no playback file, so DIVIDE cannot be executed.
No Card No SD card is in the unit. Install a recordable SD card.
No PB File
There is no file that can be played back. The file might be
damaged.
Non-Supported
The audio file is not a supported format. Please see “9 –
Connecting with a Computer” in the Reference Manual for file
formats that this unit can use.
Switched To
Internal Battery
The power supply has switched from USB bus power to the
batteries inside the unit.
Write Timeout
Writing to the SD card timed out.
Backup files on the card to a computer, and format the card.
If any other error occurs, turn the unit off and restart it.