Teac DR-60DMKII - Manual (Page 11)

TASCAM DR-60DMKII
11
9 Track status display
This icon changes according to the recording
mode.
Indicators
(examples) Meaning
Playing a file recorded in MONO
or STEREO mode
/ /
/
Monitoring in MONO mode
/ Monitoring in STEREO mode
/
Playing a file recorded in DUAL
MONO or DUAL ST mode or
monitoring in these modes
Playing a file recorded in 4CH
mode or monitoring in this
mode
0 Playback position display
The current playback position is shown by a bar.
q File name
This shows the name of the file playing back
unless there are multiple files recorded in
4-channel recording mode or dual recording
mode.
w Remaining time
This shows the elapsed time (hours: minutes:
seconds) of the current file.
e Level align status
: Level align function off
: Level align function on
r Playback equalizer status
: Playback equalizer off
: Playback equalizer on
t Peak value in decibels (dB)
The maximum level that occurs in a fixed period
of time is displayed digitally.
Preparation
Powering the unit
8 Using AA batteries
1. Remove the battery compartment cover on the
back of the unit.
2. Install 4 AA batteries with their ¥ and ^
marks as shown in the battery compartment .
3. Close the battery compartment cover.
•
Use the
BATTERY TYPE
item of the
SYSTEM
menu to set the type of battery in order to
accurately show the amount of power remaining
and allow the unit to accurately determine
whether enough power is available for proper
operation. (By default, this is set to
ALKAL
for
alkaline batteries.)
Starting up the unit
To start up the unit from the stopped state, press and
hold the button until “TASCAM DR-60DMKII”
(start-up screen) is displayed on the display.
The Home Screen appears when the unit starts up.
Setting the built-in clock
When the unit is started up for the first time (or when
the built-in clock is reset after being left unused
without batteries), the DATE/TIME screen appears
before the start-up screen to allow the date and time
to be set.
Shutting down (putting the unit
in standby)
Press and hold the button until “LINEAR PCM
RECORDER” appears on the display.
The power turns off after the unit completes its
shutdown (standby) process.