Teac DR-60D - Manual (Page 60)

60
TASCAM DR-60D
4 – Recording
Recording the moment before pushing
RECORD (PRE REC)
By using prerecording, when the unit is in recording standby you
can record up to two seconds of the signal input before the record
(0) button is pushed to start recording.(PRE REC)
1. Press the MENU button to open the
MENU
screen.
2. Turn the DATA dial to select
REC SETTING
, and press the DATA
dial or / button to open the
REC SETTING
screen.
3. Turn the DATA dial to select
PRE REC
, and press the DATA dial
or / button.
4. Turn the DATA dial to turn the pre-recording function
ON
(default
value:
OFF
).
5. When finished making the setting, press the stop (8) [HOME]
button to return to the Home Screen.
TIP
By using this in combination with the AUTO REC function, you
can record events without losing the beginnings of sounds.
NOTE
• If recording is started less than two seconds after entering record
standby, the sound since entering recording standby will be
recorded.
•
If you turn the pre-recording function on, turn the recording
delay function off.
Delaying the start of recording (REC DELAY)
You can delay the start of recording by about 0.3 seconds (fixed
time) from when you press the record (0) button.
Use this function to avoid recording the sound of pressing the
record (0) button.
1. Press the MENU button to open the
MENU
screen.
2. Turn the DATA dial to select
REC SETTING
, and press the DATA
dial or / button to open the
REC SETTING
screen.
3. Turn the DATA dial to select
REC DELAY
, and press the DATA
dial or / button.
4. Turn the DATA dial to set the recording delay function to
ON
(default value:
OFF
).
5. When finished making the setting, press the stop (8) [HOME]
button to return to the Home Screen.
NOTE
If you turn the recording delay function on, turn the pre-recording
function off.