SVSi N2000 Series - Manual (Page 47)

Page 47 N2000 Series User Manual www.svsiav.com
Chapter 3. Encoder Options Network Setup Section
Network Setup Section
The Network Setup section of the Settings page is shown in Figure 3-6 . Options are described in Table 3-4 .
Figure 3-6. Network Setup Section
Table 3-4. Settings Page: Network Setup Section
Option Description Notes
IP Mode Configure the IP address mode. When
set to AUTO IP, an IP Address in the
range of 169.254.xxx.xxx with
Netmask of 255.255.0.0 and Gateway
address of 169.254.1.1 will be
automatically assigned to the N2000
Encoder by the control software. When
set to DHCP, an IP Address in the
range of the DHCP server on the
network will be automatically assigned
to the N2000 Encoder. When set to
STATIC, an IP address, Netmask,
and Gateway address must be
manually entered. Using DHCP is generally not
recommended. If the device is set to
DHCP and fails to receive an address
from the DHCP server in time, it will
revert back to the AUTO IP Address
(169.254.xxx.xxx) until the unit is
rebooted.
IP address View the current IP address of the
N2000 Encoder. When in STATIC
mode, enter a new IP address into this
field.
Netmask View the current Netmask of the
N2000 Encoder. When in STATIC
mode, enter a new Netmask into this
field.
Gateway address View the current Gateway address of
the N2000 Encoder. When in STATIC
mode, enter a new Gateway address
into this field.