Sundance SMT310 v.1.6 - Manual (Page 21)

Page 21 of 50 SMT310 User Manual V1.6
CONFIG_L Reflects the state of the TIMs’ CONFIG signal. Active low.
Table 9 : Status Register
INTD is the input interrupt into the PCI Bridge from the SMT310, this can be routed to
either INTA, INTB, or INTC using the PCI Interrupt Configuration Register (offset
0x4C, BAR0)
9.4 Interrupt Control Register (Offset 0x18, BAR1)
This write-only register controls the generation of interrupts on the PCI bus. Each
interrupt source has an associated enable and clear flag. This register can be written
with the contents of bits 7:0 of the Status Register.
10 9
DSP-PC IIOF2 En DSP-PC IIOF1 En
8 7 6 5 4 3 2 1 0
DSP-PC
IIOF0 En
CLEAR
C40 INT
0 CLEAR
IBF INT
CLEAR OBE
INT
C40 IE TBC IE IBF IE OBE IE
DSP-PC IIOF2 En Enables DSP-PC interrupts on IIOF2
DSP-PC IIOF1 En Enables DSP-PC interrupts on IIOF1
DSP-PC IIOF0 En Enables DSP-PC interrupts on IIOF0
IBF IE ComPort Input Buffer Full Interrupt Enable. Allows an
interrupt to be generated when the host ComPort input
register is loaded with data from the C40.
OBE IE ComPort Output Buffer Empty Interrupt. Allows an interrupt to
be generated when the host ComPort register has transmitted
its contents.
TBC IE Test Bus Controller Interrupt Enable. Interrupts from the
Texas JTAG controller are enabled when set.
C40 IE C40 Interrupt Enable. Allows a programmed interrupt to be
generated by the C40 when set.
CLEAR OBE INT Write a one to this bit to clear the interrupt resulting from a
ComPort output event.
CLEAR IBF INT Write a one to this bit to clear the interrupt event resulting
from ComPort input.
CLEAR C40 INT Write a one to this bit to clear down the C40 INT event.