Sloan ELS-63000 Installaton - Manual (Page 7)

7
A
Install water Supply Line.
A
Connect one Power Cable from each Control Module to a Twist
On Terminal. Connect second Power Cable from each Control
Module to a second Twist On Terminal.
B
Connect terminals to
transformer.
C
Plug Transformer into outlet.
Faucet Power Cables
Control Modules
Transformer
Twist On Terminals
Twist On
Terminals
9 – CONNECT SUPPLY LINE TO THERMOSTATIC MIXING VALVE
10 – TURN ON WATER SUPPLY, CHECK FOR WATER LEAKS AND INSTALL END CAPS
8 – CONNECT FAUCET POWER CABLES TO TRANSFORMER AND PLUG TRANSFORMER
INTO RECEPTACLE
END CAP
Double Station Sink Shown
A
Turn on water supply.
C
Replace End Caps. Insert the screw located on the inside of the
Cap into the enlarged hole of the Frame. Then slide the Cap into
place. Loosely install the two front screws. Slide End Cap UP to
eliminate any gap between the End Cap and Basin. Tighten the
inside screw securely. Lastly, tighten the two front screws
securely. Follow the same procedure for the second End Cap.
B
Check all plumbing for water leaks.