Sloan ELS-63000 Installaton - Manual (Page 5)

3 – REMOVE END CAPS FROM FRAME
4 – MOUNT FRAME TO WALL (FOR ELS-70000 SERIES)
5
Bottom Backside of Frame
Front of Frame
End Cap (2)
Enlarged Hole and
Slot in Frame
A
Loosen (do not remove) screws on inside of frame.
C
For triple station sinks,
remove the Front Panel
Support.
B
Remove both End
Caps by removing
the two outer
screws on each Cap.
Slide Cap forward in
slot and pull it out
through enlarged
hole in Frame.
Front Panel Support
Triple Station Double Station
FINISHED FLOOR
D
(See VARIABLE
MOUNTING
HEIGHT CHART
On Page 2)
C
For triple station sinks, reinstall the Front Panel
Support.
A
If desired, apply adhesive to back surfaces of Frame.
B
Mount Frame to wall using 3/8" fasteners with 1000 lb min
pull out strength in the following locations:
1. Each hole in the extreme outer corners of top support
2. One of either of the two holes in the top position of each
upright
3. The lower hole location in each upright
Fasteners may be optionally applied to any of the remaining
mounting hole locations.
Level Frame in both directions before tightening fasteners
securely.
Front Panel Support
D
For installations including the optional SJS-1650 Soap Dispenser,
refer to Soap Dispenser Installation Instructions.