Sloan ELC-81000 Installaton - Manual (Page 7)

7
Troubleshooting Guide
See Troubleshooting section in the installation instructions
furnished with the faucet(s).
Operation
As the user’s hands pass under
the faucet spray head and enter
the beam’s effective range, the
beam is reflected back into the
sensor receiver and activates the
solenoid valve allowing water to
flow from the Spray Head. Water
will flow until the user’s hands are
removed from under the Spray
Head or until the automatic time
out limit setting is reached.
Care and Cleaning
SloanStone Solid Surface Care
For normal cleaning, use warm, soapy water or conventional ammonia
based liquid glass cleaner.
For dry stains, allow the soapy water or glass cleaner some time to
remoisturize the area, then wipe the stain off.
To renew the surface after deep scratches or stains, use green, then
maroon, and finally white 3M Scotch-Brite® pads to return the deck to
a smooth 1200 grit wet-sanded finish.
If the dry stain is neither water-based nor oil-based, gently scrape the
stain off with a plastic material (i.e. a plastic knife), and then proceed with
the aforementioned normal cleaning procedures.
Wipe the entire surface evenly with a mild abrasive cleanser for regular
maintenance.
Stainless Steel Care
Important: When cleaning stainless steel, always rub in the same
direction of the stainless steel finish lines, never across. After cleaning,
always thoroughly rinse with water and dry all cleaned stainless steel
areas to prevent buildup of mineral deposits.
Clean stainless steel surfaces often using warm, soapy water.
For more stubborn deposits, use baking soda, borax or any of several
non-abrasive commercial cleansing agents. Do not leave chlorides found
in most cleansing agents for extended periods of time on the surfaces as
they may attack stainless steel. If an abrasive cleaning tool is needed,
always use stainless steel wool, stainless steel pads, or stainless steel
brushes. Do not use ordinary steel wool, pads or brushes because the
have a tendency to break apart and leave small particles which will rust
on the stainless steel surfaces, giving the appearance that the stainless
steel surfaces themselves are rusting. Do not use strong acidic or caustic
cleaners or cleansers because they may also attack the stainless steel
surfaces. Maintain a regular cleaning schedule.
8 Install Access Panels
B
Slide Access Panel up through the slot in each side of the
Cabinet.
Access Panel
C
Secure Access Panel using two fasteners provided. For double
and triple station sinks, install the remaining Finger Guards and
Access Panels in the same manner.
Fasteners
When assistance is required, please contact Sloan Valve Company
Installation Engineering Department at:
1-888-SLOAN-14 (1-888-756-2614)
OR 1-847-233-2016
A
Install Finger Guard(s) onto the top edge of the Access
Panel(s).
Finger Guard
D
Remove all protective plastic and clean and polish all stainless.