Skutch Electronics BA-1000-A V4.00 - Manual (Page 2)

Version 4.00 Page 2
BA-1000-A Quick Start Guide V4.00
Record an Outgoing Message
1- Connect the Microphone to the Mic jack on the rear of
the BA1000A.
2- Press
~
3- Press and "Hold Down" 5
4- When "BEEP" stops, immediately start dictating your
new Outgoing message. Release
5 when finished.
5- Unplug the Microphone. That's it!
Sample Message: "ABC Productions! I'm sorry but we
are not available to answer your call at this time. If you
need immediate assistance, please leave your message
then dial 8 on your telephone and we will return your
call very shortly. Thank you."
Test your Outgoing Message
1- Press ~.
2- Press and HOLD DOWN 6 until unit BEEPS. Then
release.
Note: To turn the volume UP, tap 9 several times.
Tapping 7 turns the volume DOWN.
Local Programming of
Notification Numbers
1- Press ~, wait for BEEP. Wait 5 seconds.
2- Press 123.
3- Wait 5 seconds, press #.
For this example we are entering a home phone number,
then a pager phone number.
786-6100 (Home)
343-2234 (Pager) Pager to display 1234.
4- Press:
137866100#. Wait
for BEEP.
5- Press:
113432234*2
1234*4#. Wait for BEEP.
6- Press
~.
The Special Codes for dialing are:
*00 = Next digit will be dialed for 5 sec.
*0x =Variable Pause where x = sec 1-9
*1= Return Dial Tone Detect
*2 = Wait for five Seconds of Silence
*3 = Dial Touch Tone STAR
*4 = Dial Touch Tone POUND
*5 = Change to TONE Dial mode.
*6 = Perform a Hook Flash.
Set to Auto Answer
1- Press ~.
2- Press and HOLD DOWN * until you hear a BEEP,
then release. To EXIT to IDLE mode, press ~.
Local Playback
1- Press ~, wait for BEEP!
2- Press and HOLD DOWN 4 until unit BEEPS, then
release.
Remote Playback
1- Call BA1000 from a touch tone telephone.
2- During the message, press:
*1234#.
The system will playback URGENT messages first. When
it is finished, it will BEEP 3 TIMES if there are other
messages on the system. To hear the other messages press
0 within 4 seconds.
• Remote Programming of Notification
Numbers
1- Call BA1000 from a touch tone telephone.
2- During the message, press:
*0506#
1.
To exit, press
**.
• Remote Outgoing Message Record
1- Call BA1000 from a touch tone telephone.
2- During the message, press:
*0506#
5.
After BEEP, start dictating new Message. Press
* to
end. (Must be at least 5 sec long).
To exit, press
*.
• Remote Group Number
Programming
1- Call BA1000 from a touch tone telephone.
2- During the message, press:
*0506#
8.
To exit, press
*.