Sim2 Crystal - Manual (Page 40)

40 Using the projector
Setup menu
Information menu
This menu shows you the current operating status of the projector.
Some picture adjustments are available only when certain input sources are in use. Unavailable
adjustments are not shown on the screen.
Function Description
Lamp Settings
Lamp Power
Selects the projector lamp power between Normal and Economic
modes.
Equivalent Lamp Hour
Shows the lamp hour information. See "Getting to know the lamp
hour" on page 42 for details.
HDMI Settings
Selects an input source type for the HDMI signal. You can also
manually select the source type. The different source types carry
different standards for the brightness level.
This function is only available when the HDMI signal is selected.
Baud Rate
Selects a baud rate that is identical with your computer’s so that
you can connect the projector using a suitable RS-232 cable and
update or download the projector’s firmware. This function is
intended for qualified service personnel.
Test Pattern
Press ENTER to display the grid test pattern. It helps you adjust the
image size and focus and check that the projected image is free
of distortion.
The function is only available when the projector detects no
input signal.
High Altitude Mode
A mode for operation in areas like high altitude or high
temperature. See "Operating in a high altitude environment" on
page 31 for details.
Password Not used.
Reset All Settings
Returns all settings to the factory preset values.
The following settings will still remain: names of user modes, Keystone,
Language, Projector Position, and High Altitude Mode.
Function Description
Source Shows the current signal source.
Picture Mode Shows the selected mode in the Image > Picture Mode menu.
Resolution Shows the native resolution of the input source.
Equivalent Lamp
Hour
Shows the total lamp time used.
Firmware Version Shows the firmware version of your projector.