Sim2 Crystal - Manual (Page 3)

3 Important safety instructions
Thank you for your purchase of this quality video projector! It has been designed to
provide you with an enjoyable home theater viewing experience. For the best results,
please read this manual through carefully as it is your guide through the control menus
and operation.
Important safety instructions
Your projector is designed and tested to meet the latest standards for safety of
information technology equipment. However, to ensure safe use of this product, it is
important that you follow the instructions mentioned in this manual and marked on the
product.
1. Please read this user manual before you operate your projector. Keep this manual in a
safe place for future reference.
2. Always place the projector on a level, horizontal surface during operation.
- Do not place the projector on an unstable cart, stand, or table as it may fall and be
damaged;
- Do not place inflammables near the projector;
- Do not use if tilted at an angle of more than 10 degrees left to right, nor at angle of more
than 15 degrees front to back.
3. Do not store the projector on end vertically. Doing so may cause the projector to fall over,
causing injury or resulting in damage.
4. Do not place the projector in any of the following environments:
- space that is poorly ventilated or confined. Allow at least 50 cm clearance from walls
and free flow of air around the projector;
- locations where temperatures may become excessively high, such as the inside of a car
with all windows closed;
- locations where excessive humidity, dust, or cigarette smoke may contaminate optical
components, shorten the projector’s lifespan and darken the screen;
- locations near fire alarms;
- locations with an ambient temperature above 35°C/95°F;
- locations where altitude is higher than 1500 meters/4920 feet above sea level.
5. Do not block the vents holes while the projector is on (even in standby mode):
- Do not cover the projector with any item;
- Do not place the projector on a blanket, bedding or any other soft surface.
6. In areas where the mains power supply voltage may fluctuate by 10 volts, it is
recommended that you connect your projector through a power stabilizer, surge
protector or uninterruptible power supply (UPS) as appropriate to your situation.
7. Do not step on the projector or place any objects upon it, glass surface could be
damaged.
8. Do not place liquids near or on the projector. Liquids spilled into the projector will void
your warranty. If the projector does become wet, disconnect it from the power supply.
9. Do not look straight into the projector lens during operation. It may harm your sight.
10. Do not operate the projector lamp beyond the rated lamp life. Excessive operation of
lamps beyond the rated life could cause a lamp to break on rare occasions.
11. Never attempt to replace the lamp assembly until the projector has cooled down and is
unplugged from the power supply.
12. When you think service or repair is required, take the projector only to a suitably qualified
technician.