Sim2 Crystal - Manual (Page 25)

25 Using the projector
Fine-tuning the picture quality
No matter what picture mode you have selected, you are able to fine-tune those
settings to fit every presentation purpose. Those adjustments will be saved to the preset
mode you are at when you exit the OSD menu.
Adjusting Brightness
Highlight Brightness in the Image menu and adjust
the values by pressing / on the projector or
remote control.
The higher the value, the brighter the picture. And
the lower the setting, the darker the picture.
Adjust this control so the black areas of the picture appear just as black and that detail
in the dark areas is visible.
Adjusting Contrast
Highlight Contrast in the Image menu and adjust
the values by pressing / on the projector or
remote control.
The higher the value, the greater the contrast. Use
this to set the peak white level after you have
previously adjusted the Brightness setting to suit your selected input and viewing
environment.
Adjusting Color
Highlight Color in the Image menu and adjust the values by pressing / on the
projector or remote control.
Lower setting produces less saturated colors; setting to the minimum value makes the
image black and white. If the setting is too high, colors on the image will be
overpowering, which makes the image unrealistic.
Adjusting Tint
Highlight Tint and adjust the values by pressing / on the remote control.
The higher the value, the more reddish the picture becomes. The lower the value, the
more greenish the picture becomes.
Adjusting Sharpness
Highlight Sharpness and adjust the values by
pressing / on the remote control.
The higher the value, the sharper the picture
becomes. The lower the value, the softer the
picture becomes.
30 50 70
30 50 70
3 5 7