Sim2 Crystal - Manual (Page 18)

18 Positioning your projector
Connecting component-video devices
Be sure to match the corresponding colors between the cables and the terminals. The
RCA type component video jacks are provided for connection to video output devices.
You should also connect the separate audio cable to a suitable audio amplifier.
Connecting S-Video or video devices
You need only connect S-Video or composite Video cable from the same device, never
both at the same time. You should also connect the separate audio cable to a suitable
audio amplifier.
• If you have already made a Component Video connection between the projector and the video
source device, you need not connect to this device again using an S-Video or composite Video
connection as this makes an unnecessary second connection of poorer picture quality. You need
only connect using a composite Video connection if both Component Video and S-Video are not
supplied on the video source device (for example, with some analog video cameras).
• If the selected video image is not displayed after the projector is turned on and the correct video
source has been selected, please check that the video source device is turned on and operating
correctly. Also check that the signal cables have been connected correctly.
AV equipment: DVD player,
digital tuner, etc.
From audio output
terminals
To audio input
terminals
Component video cable
From audio
output
terminals
To audio input
terminals
S-Video cable
Video cable
or
AV equipment