Seaward PATGuard Work About - Manual (Page 22)

Seaward PATGuard Work About 2 User Manual
- 22 - Rev. 1.3
Figure 23: Add Test display
There are pre-determined PAT tests available from the Test drop down. But in fact the user can enter any
Test name directly into the Test field. Tests selected from the drop down will have their UOM (Unit of
Measurement) predefined whereas for Tests you have created the UOM field will be blank so you can
enter the appropriate UOM. Select OK to save the Test into the Test Sequence.
The test added will appear in the Test Sequence display list. By selecting Add again and repeating the
above you can compile a list of Tests. Once the list is complete select OK.
This stored Test Sequence can be added to as many Assets as is necessary in the current file. To do this
select Add Test Sequence from the context menu of the required Assets individually.
Figure 24: Asset Context Menu
The Test Sequence can be altered by selecting Test Sequence from the Tools pop-up, this allows
different test sequences to be added to further Assets. Altering this Test Sequence will not affect those
sequences already stored in any Asset.
To remove a Test Sequence from an Asset select Remove Test Sequence from the context menu of the
relevant Asset.
Note
Remove Test Sequence is only available for Assets that have no test results and previously had tests
added as a complete test sequence.