Chapter nine configure remote access – RLE FMS8 User Manual
Page 79
Falcon User Guide
79
Chapter Nine
Configure Remote Access
The Falcon system can be remotely accessed with
any terminal emulation software package or with
RLE’s FalconView application software. To establish
a proper dial-out session, set the appropriate modem
port as follows:
•
33.6K
baud
•
NO
parity
•
8
bits
• 1 stop bit
•
(2400/N/8/1)
• No software or hardware flow control
Once the proper settings are made, dial the phone
number assigned to the Falcon. Once communica-
tion is established, press
Enter (
↵
)
. A
Logon>>
prompt will appear on the screen. Type the login,
press
Enter (
↵
)
, type the password, press
Enter
(
↵
)
; the session will begin. Type a
question
mark (?)
to view the System Menu. To terminate
the session, execute the command in the software
package that disconnects the modem.
The commands for accessing the system remotely are
identical to the ones described earlier in this manual.
There is, however, a limited command set for remote
access. The screen at the left shows the available
commands.
System Configuration is limited to the System Menu
section, the Modem Configuration section, and the
Configuration Password section. It is important to
note that in the Modem section, if
x Exit &
Save (Warning: This will disconnect
& initialize the modem)
is selected to save
information, the Falcon will reinitialize its modem
and terminate the connection.
Pages can be acknowledged by phone number during
a remote access session by entering
aa
followed by
the alarm acknowledgement code for that phone
number.
** System Menu/Help **
SS - System Status
CA - Current Alarms
KA - Kill All Alarms
LM - Log Menu
TI - Display Date/Time
AD - ADC Input Values
MS - Modem Stats
SC - System Confi g