RLE FMS8 - Manual (Page 10)

Falcon User Guide
10
Network LEDs – Two network status LEDs:
• Link - Green if network link is established, red if not.
• Active - On (green) when the link is transmitting or receiving data.
Communications LEDs – Four modem status LEDs:
• TX - On (green) – Information is being transmitted.
• RX - On (green) – Information is being received.
• OH - On (green) – Modem detects a dial tone (off hook).
• CD - On (yellow) – Carrier detected.
System Status LED – This LED illuminates (red) during initial boot of the system and flashes ten times per
second. If the initial boot fails, the LED continues to flash. This indicates a condition that requires service.
During normal operation, the system status LED turns solid red when the unit is in alarm condition.
Power LED – On (green) as long as power is on.
System Power Switch – Used to turn power to the unit on and off.
Falcon - Front Panel Indicators and Controls
Network LED - Link
Network LED - Active
Communications LED - TX
Communications LED - RX
Communications LED - OH
Communications LED - CD
System Status LED
Power LED
System Power Switch
alarm after three invalid entries. Access codes can
also be entered via telephone using DTMF signaling
– just dial the unit and enter the access code
followed by the
# key . A valid entry activates
an output relay for a user-defined period of time,
which in turn activates an equipment door latch or
electrical lock on an entrance door. An alarm bypass
feature is also provided for doors equipped with a
forced entry alarming contact.