Dialogic Mitel SX-2000 - Manual (Page 6)

Mitel SX-2000 Lightware
6
Note: The number of TDM circuits varies depending on the used Dialogic
®
Media Gateway model.
For this setup:
• Set the property Switch Type to Q-SIG T1 .
• If your PBX does not provide ring tones to callers from TDM, set the property Generate Ring
Tones to Yes .
To activate the change, click
File > Activate .
Make these configuration changes for each TDM circuit you are going to use on the Dialogic
®
Media Gateway.
5.2 Dialogic
®
Diva
®
SIPcontrol™ Software Gateway Application
The Diva SIPcontrol software is configured via the web based interface. To open the web interface, click
Start
> Dialogic Diva > SIPcontrol Configuration .
On the main page, click the
SIPControl link to display the different configuration menus.
The PSTN Interface Configuration section should automatically include all ports detected in the system.
Note: If you do not see any detected ports, you may need to add
http://127.0.0.1 as a trusted site. From
Microsoft
®
Internet Explorer, click Tools > Internet Options > Security > Trusted Sites . Use
http://127.0.0.1:10005 to get to the configuration.
In order for the Diva SIPcontrol software to route calls, the proper routes must be created and configured. Each
route consists of a source interface and a destination interface. PSTN controllers and SIP peers are considered
either a source interface or a destination interface depending on the call direction.
5.2.1 PSTN Interface and Network Interface Configuration
The following is a typical configuration.