REMKO RXD Series - Manual (Page 9)

MODE Button
Press the MODE button once or repeatedly to switch to automatic mode.
In this mode, the regulation automatically selects COOL or HEAT mode
depending on the temperature. The temperature is then maintained at
the set value. This function should only be used on RXS...H units. Only
cooling mode is activated on RXM units; heating mode is not supported.
The FAN should be set to AUTO.
Press the MODE button to change to another mode. A total of 5 modes
are available:
1. Automatic Automatic selection of cooling or heating operation
2. Cooling Cooling mode, predominantly used during summer
3. Dehumidification Dehumidifying mode, used in summer or winter
4. Air circulation Circulation mode, no cooling or heating output
5. Heating Predominantly used during winter (only for RXS...H)
MODE MODE MODE MODE
Mode AuTO
MODE
TEMP COOLING
or
HEATING
Set temperature is below the
room temperature
Set temperature is above the
room temperature
Press the MODE button once or repeatedly to switch to cooling mode.
Use this mode to cool the room air to the desired target temperature.
Press the TEMP
▲/▼ buttons to set the desired room temperature
in 1 °C steps. If the room temperature is 1 °C above the desired
temperature and sufficient coolant is available, the indoor unit will start
to cool the room air. f the actual temperature falls approx. 0.5 °C below
the set room temperature, the controller switches the cooling off.
Mode COOL
MODE
COOLING MODE
It is recommended that the
target temperature is set to
max 6 °C below the outdoor
temperature. The automatic
fan speed and swing functions
should also be used.
TIP
9