REMKO RXD Series - Manual (Page 6)

Infrared remote control
The infrared remote control
sends the programmed settings
at a distance of up to 6 m to the
receiver on the interior unit.
Data will only be received correctly
if the remote control is pointed
at the receiver and no objects are
obstructing the transmission path.
First insert the supplied batteries (2
each, type AAA) into the remote
control. To do so, remove the
cover on the battery compartment
and insert the batteries. Take into
account the correct polarity (see
markings).
Immediately replace flat
batteries with a new set,
otherwise there is a risk of
leakage. It is recommended that
the batteries are removed if the
equipment is shut down for
long periods.
NOTE
max. 6 m
Max. distance 6 m
The indoor unit is easy to operate
using an infrared remote control.
This is supplied as standard. The
indoor unit beeps to acknowledge
the correct transmission of data.
If it is not possible to program
the indoor unit using the remote
control, it can also be manually
operated.
Display on indoor unit
The lit display LEDs indicate the settings.
LED H red = high fan speed
LED M yellow = medium fan speed
LED L green
= low fan speed
Manual operation
The indoor units can be started
manually.
Press the RESET button on the
receiver unit of the cover to
activate automatic mode. In manual
operation, the following settings
apply:
Cooling mode: 24 °C,
Fan speed: AUTO
Heating mode: 26 °C,
Fan speed: AUTO
Pressing any button on the infra-
red remote control interrupts
manual operation
Display on indoor unit
Unit for receiving signals
from the remote control
LED
H
LED
M
LED
L
RESET button
Manual operation
Operation
Problems are shown in code
(see chapter on trouble-
shooting and customer
service).
CAUTION
REMKO RXD
6