REMKO RXD Series - Manual (Page 7)

"SWING" Button
This button switches on the
oscillating fins to provide
improved air distribution in the
room. It can also be used to
lock the fins.
"FAN" button
Press this button to set the
required fan speed. 4 levels
are available: Automatic, high,
medium and low fan speed.
"TIME-OFF" Button
This button is used to program
the automatic switch-off
function for the indoor unit.
"TIME-ON" Button
This button is used to program
the automatic switch-on
function for the indoor unit.
"C" Button
Press this button to activate the
time setting.
"R" Button
Press this button to reset the
remote control to its factory
default configuration.
"NETWORK" Button
This button has not been
assigned a function.
"SLEEP" Button
Pressing this button will
automatically increase or
decrease the target temperature
by 1 °C within an hour in
cooling and heating mode
respectively.
Buttons on the remote control
"POWER" button
Press this button to start the
unit.
"TEMP" Button
Press this button to set the
desired temperature in 1 °C
steps within the range 16 °C to
30 °C.
"TIME-SET" Button
Press this button to set the
time.
"MODE" button
Press this button to select the
operating mode. The indoor unit
has 5 modes:
1. Automatic mode
(COOL/HEAT):
In automatic mode, the
temperature is maintained at
the target temperature.
2. Cooling mode (COOL):
In cooling mode, the warm
room air is cooled to the lower
preset target temperature.
3. Dehumidifying mode (DRY):
In this mode the room is mainly
dehumidified.
4. Circulation mode (FAN)
In circulation mode only the
air is circulated. The room
temperature is not controlled.
5. Heating mode (HEAT):
(only for RXS...H)
In heating mode the cold room
air is heated to the preset higher
temperature.
This mode should not be used
on RXM units (malfunctions may
occur)!
Buttons on the remote control
7