beautypg.com

Remko rxd – REMKO RXD Series User Manual

Page 10

background image

Mode DRy

Press the MODE button once or repeatedly to switch to dehumidifying

mode. Use this mode to dehumidify the room in an unregulated fashion.

After pressing the DRY button, select the desired temperature and fin

position. It is not possible to set the fan speed. The fan is switched off at

certain intervals to lower the temperature at the cooling battery. The low

temperature causes the air temperature at the fins to fall below the dew

point. Excess humidity in the air condenses on the cooling battery and

the room is dehumidified.

MODE

DEHUMIDIfyING MODE

Mode FAN

Press the MODE button once

or repeatedly to switch to

circulation mode. In this mode,

the equipment is used as an

air circulation unit. The room is

neither heated nor cooled.

MODE

CIRCULATION MODE

This mode is used in winter

to circulate the heat trapped

under the ceiling to the lower

regions of the room.

TIP

Mode HEAT

Press the MODE button once or repeatedly to switch to heating mode.

Use this mode to heat the room air to the desired target temperature.

This function should only be used on RXS...H units. Only cooling mode is

activated on RXM units; heating mode is not supported.
The fan will only start when the fin temperature reaches 38°C.
Press the TEMP

/ buttons to set the desired room temperature

in 1 °C steps. If the room temperature falls 1 °C below the set target

temperature, heating mode is activated. f the actual temperature rises

approx. 1 °C above the set room temperature, the controller switches the

heating off.

MODE

HEATING MODE:

It is recommended that the

target temperature is set to

max. 28 °C. Maximum fan

speed and the lowest fin

setting should also be used.

NOTE

SWING Button

The SWING button is used to provide continual and automatic vertical

adjustment of the fins. This facilitates improved distribution of the cooled

air inside the room. If the SWING button is pressed during the swing

motion, the fins stop in their current position. Pressing the button again

resumes the swing motion.

SWING

SWING

REMKO RXD

10

SWING

SWING

SWING

SWING