REMKO RXD Series User Manual

Page 11

TIME Buttons

Switch-on time

Switch-off time

The TIME-ON/-OFF buttons are used to program the switch-on/off time,

the TIME-SET button to set the time.
Press the TIME-ON or TIME-OFF button to activate the timer. The clock

display then disappears. The timer symbol for the switch-on/off time will

flash. Press the TIME-SET button to set the desired switch-on/off time in

10 minute steps.
After programming has been completed, the settings are transmitted to

the indoor unit. For delayed switch-on press the TIME-ON button, for

delayed switch-off press the TIME-OFF button. The timer symbol will

stop flashing and the indoor unit beeps to acknowledge the programmed

parameters.
When the programmed time has been reached, the device is

automatically turned on or off. If the indoor unit is automatically

switched on, then the mode, temperature and fan speed for the last

setting is reactivated.
The switch-on/off time can be prematurely cancelled by pressing the

appropriate TIME button or POWER button

TIME-ON

TIME-SET

TIME-ON

Switch-on time

TIME-OFF

TIME-SET

Switch-off time

TIME-OFF

After the SLEEP button is pressed, the symbol is shown on the display

and the room temperature is raised or lowered by 0.5 °C in cooling and

heating mode respectively 30 minutes after the function starts up. After

a further 30 minutes the room temperature is raised or lowered by 1 °C

in cooling and heating mode respectively. After a further hour the room

temperature is held at a constant 2°C above or below the original target

temperature in cooling and heating modes respectively. The temperature

is then maintained at a constant level. This function is disabled by pressing

the POWER or SLEEP button. The symbol on the display goes out.

SLEEP Button

SLEEP

HEATING
MODE:

COOLING
MODE

The NETWORK button on RXD units has not been assigned a

function.

NETWORK Button