REMKO RXD Series - Manual (Page 13)

Air filter for indoor unit
Clean the air filter at intervals of
no more than 2 weeks. Reduce this
interval if the air is especially dirty.
Cleaning the filter
1. Disconnect the supply voltage
to the equipment.
2. Open and fold down the air
inlet guard on the cover. The
filter is held in place by the flaps
screwed in at the side of the
guard (Fig. 1).
3. Tilt the filter to lift it out (Fig. 2).
4. Clean the filter using a normal
vacuum cleaner (Fig. 3). Turn
the dirty side until it faces up.
5. Any dirt can be cleaned off
using lukewarm water and mild
cleaning agents.
To do so, turn the dirty side
downward (Fig. 4).
6. When using water, allow the
filter dry out properly in air
before replacing it in the unit.
7. Carefully insert the filter. Make
sure it is seated correctly.
8. Close the cover as described
above but in reverse order.
Cleaning the condensation
pump
The indoor unit includes a built-in
condensation pump, for pumping
the condensation to a drain at
a higher level.
The pump is more or less
maintenance free. The condensation
pipes should be checked for dirt
at regular intervals. Clean them as
required.
If an external pump is also used,
observe the maintenance and care
instructions given in the separate
operating manual.
1 Guard on cover
2 Pull out the filter
3 Clean with a vacuum cleaner
4 Cleaning with lukewarm water
9. Switch the supply voltage back
on.
10. Switch the unit back on.
13