REMKO ATY 261 - Manual (Page 4)

Safety notes
Carefully read this manual before
starting the unit for the first time. It
contains useful tips and notes as
well as hazard warnings to prevent
injury or material damage . Non-
observance of this manual may
endanger persons, the environment
as well as the equipment itself and
will void any claims for liability.
■
Store this manual and the
refrigerant datasheet in the
vicinity of the unit.
■
The unit should only be set
up and installed by qualified
personnel.
■
The setup, connection and
operation of the unit and
its components must be in
accordance with the operating
conditions stipulated in this
manual and comply with all
applicable local regulations.
■
Units designed for mobile use
should be safely set up on a
suitable floor and in a vertical
position.Units designed for
stationary use should only be
operated in their permanently
installed state.
■
It is prohibited to make
modifications or changes to
equipment or components
supplied by REMKO as this may
cause malfunctions.
■
Equipment and components
should not be operated in areas
where there is a heightened
damage risk. Observe the
minimum clearances.
■
The electrical supply should
be adapted to fulfil the
requirements of the unit.
■
The operational safety of
equipment and components is
only assured providing they are
used as intended and in a fully
assembled state. Safety devices
should not be modified or
bypassed.
■
Do not operate equipment
or components with obvious
defects or signs of damage.
■
All housing parts and openings,
e.g. air inlets and outlets, must
not be blocked by foreign items,
fluids or gases.
■
The equipment and components
must be kept a safe distance
from inflammable, explosive,
combustible, agressive and dirty
areas or atmospheres.
■
Persons coming into contact
with equipment parts may suffer
burns or injury.
■
Installation, repair and
maintenance work should only
be carried out by authorised
specialists. Inspection and
cleaning can be performed
by the operator providing the
equipment is not under voltage.
■ <
Take appropriate hazard
prevention measures when
performing installation, repair or
maintenance work or cleaning
the equipment.
■
The equipment and components
should not be exposed to any
mechanical stresses, extreme
levels of humdity or direct
exposure to sunlight.
Disposal of packaging
All products are carefully packaged
using environmentally friendly
materials prior to transportation.
Make a valuable contribution to
reducing waste and sustaining
raw materials. Only dispose of
packaging at approved collection
points.
Disposal of
old equipment
Equipment manufacture is subject
to continuous quality control. Only
high-quality materials are used, the
majority of which can be recycled.
Help protect the environment by
only disposing of old equipment in
accordance with local regulations
and in an environmentally safe
manner, e.g. through authorised
disposal and recycling specialists or
at collection points.
Warranty
In order to make warranty claims, it
is essential that the ordering party
or their representative complete
and return the "certificate of
warranty" and commissioning
report to REMKO GmbH & Co. KG
at the time when the equipment
was purchased and commissioned.
The warranty conditions are
detailed in the "General terms
and conditions“. The contractual
parties can also agree additional
terms beyond the scope of the
above. In this case, first contact the
contractual partner.
Environmental
protection
and recycling
REMKO ATY
4