REMKO ATY 261 - Manual (Page 14)

Regular care and observance of
some basic points will ensure
trouble-free operation and a long
service life.
Prior to performing any
work, ensure the equipment
is isolated from the voltage
supply and secured to prevent
accidental switch-on!
CAUTION
Temporary hutdown
1. Let the indoor unit run for 2 to
3 hours in circulation mode, or
in cooling mode at maximum
temperature, to extract any
residual humidity from the unit.
2. Shut down the unit using the
remote control.
3. Switch off the supply voltage
to the unit.
4. Check the unit for visible
signs of damage and clean as
described in the chapter "Care
and maintenance".
Permanent shutdown
Ensure that equipment and
components are disposed of
in accordance with local
regulations, e.g. through
authorised disposal and recycling
specialists or at collection points.
REMKO GmbH & Co. KG or their
authorised partners will be pleased
to provide details of specialists in
your area.
Care
■
Ensure the indoor unit is
protected against dirt, mould
and other deposits.
■
Clean the indoor unit and
outdoor component using a
damp cloth. Do not use any
caustic, abrasive or solvent-
based cleaning products.Do not
use a jet of water.
■
Clean the fins on the unit prior
to long shutdown periods.
Maintenance
■
It is recommended that you
take out a maintenance contract
with an annual service from an
appropriate specialist firm.
This ensures the operational
reliability of your equipment!
TIP
Shutdown Care and maintenance
Ensure the unit is not under
voltage when performing care
and maintenance tasks.
CAUTION
Cleaning the housing of the
indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Clean the unit using a soft,
damp cloth.
3. Switch the supply voltage back
on.
Air filter for indoor unit
Clean the air filter at least every 2
weeks. Reduce this interval if the
air is especially dirty.
Cleaning the filter in the
indoor unit
The indoor unit is equipped with
a filter that has an antibacterial
coating. The filter removes dust
from the air and reduces the
spread of bacteria.
1. Switch the indoor unit to
circulation mode using the
remote control (open the front
cover for the air inlet!) (Fig 1).
2. Open the lower display cover
on the front of the unit by
pressing both stops and
carefully folding the cover
down to lift it out of the
support (Fig 2).
REMKO ATY
14