REMKO BL 262 DC User Manual
Page 17
Indicators on the LCD
2
1
4
3
5
7
9
6
8
Fig. 13: Indicators on the LCD
1: Mode indicator - shows the current operating
modes, including Auto ( ), Cooling ( ), Dehu-
midification ( ), Heating ( ), Fan ( ) and
back to Auto ( ) mode.
2: Signal transmission symbol. This symbol
appears when signals are being transmitted
from the remote control to the indoor unit.
3: ON/OFF symbol. This symbol appears when
the "ON/OFF" key is pressed. Pressing this key
again causes the indicator to go out.
4: TIMER ON symbol. This symbol appears when
TIMER ON is switched on.
5: TIMER OFF symbol. This symbol appears
when TIMER OFF is switched on.
6: Sleep symbol. This symbol appears when the
"Sleep" function is activated. Pressing this key
again causes the indicator to go out.
7: Temperature/Timer symbol. Shows the temper-
ature setting (-17°C~30°C). If "FAN" mode is
selected, the temperature setting is not dis-
played. In Timer mode, the ON and OFF set-
tings appear for the TIMER.
8: FOLLOW ME symbol. This symbol appears
when the "Follow me" function is activated.
9: Fan speed symbol. This is where the selected
fan speeds are displayed: AUTO (no indicator)
and the three fan speed settings:
(slow),
(medium) and
(fast). The fan speed is set to "Automatic"
when either "Auto" or "Dehumidification" mode
is activated.
The illustration of the LCD with all of the sym-
bols present is only intended to provide a
clearer overview. During operation, only those
symbols relevant to the respective functions
appear on the display.
Key functions
A symbol is shown on the display to indicate that
the settings are being transferred.
"Auto" mode
Make sure that the indoor unit is connected to the
power supply, and is switched on.
The operating mode indicator on the display of the
indoor unit begins to flash.
1.
Press the "MODE" key to select "Auto"
mode.
2.
Press the "UP/DOWN" key to set the desired
temperature. The temperature can be set
between 17 and 30°C, in increments of 1°C.
3.
Press the "ON/OFF" key to switch on the air
conditioning unit.
1
3
2
Fig. 14: "Auto" mode
–
In "Auto" mode, the air conditioning unit is
able to logically select between the
"Cooling" , "Recirculation" and "Heating"
modes, specifically by detecting the differ-
ence between the actual room temperature
and the temperature set on the remote
control.
–
In "Auto" mode, it is not possible to set the
fan speed. This is already controlled auto-
matically.
–
If "Auto" mode is not comfortable enough
for you, you can also select the desired
mode manually.
17