OpenEye CM-816 - Manual (Page 34)

30875AF 35
To set up a new static IP address:
1. Select the Use static IP address option.
2. Type a new IP address in the IP address box.
3. Type a new address in the Default Gateway box.
4. Click Apply to confirm the new setting.
When using static IP address to log in to the IP Camera, you can access it either
through OpenEye IP Finder software or type the IP address directly in the address bar of
your Internet Explorer.

IP Address – The IP Address is necessary for network identification.

Subnet mask
–
Used to determine if the destination is in the same subnet. The
default value is 255.255.255.0.

Default gateway – Used to forward frames to destinations on different subnets
or for internet access.

Primary DNS
–
The primary domain name server that translates hostnames
into IP addresses.

Secondary DNS
–
A secondary domain name server that backups the primary
DNS.

Web Server port – Defines the port that Internet Explorer uses to connect over
the web and view video. If this port is changed then the new port must be
defined when attempting to web connect (ex: if your camera’s IP address is
192.168.0.100 and you change the web port to 8001, then you must type
http://192.168.0.100:8001 in your browser).

RTSP port
–
The default RTSP port is 554; setting range: 1024 ~65535.

MJPEG over HTTP port – The default HTTP Port is 8008; setting range: 1024
~65535.

HTTPS port – The default HTTPS Port is 443; setting range: 1024 ~65535.
No port number can be used in duplication on more than one item.
IPv6 Address Configuration
To enable IPv6 select Enable IPv6 and click Save . See your network administrator if
you are unsure of your network configuration.