OpenEye SW-RWTCP - Manual (Page 27)

27314AI 27
POSITOUCH CONFIGURATION
Note: The Electronic Journal software from POSitouch is required.
Set up BOW
1. Exit POSitouch terminal.
2. Run BOW at C:\SC\BOW.exe
3. Click Setup and select Hardware.
4. Select Number of Serial Devices and increase the Number of prep printers by 1, and then click OK.
5. Select Prep Printers and click Locations and Types.
6. Select a blank line (if there are no blank lines, click Insert), name the printer Journal, and then click Yes.
7. Click Edit.
8. In the Location box type DVR PRINTER.
9. From the Printer Type list, select 1- Virtual Printer.
10. Click OK.
11. Click Exit to Hardware Setup: Prep Printer Locations and Types: Edit window.
12. Click Exit to Hardware Setup: Prep Printer Locations and Types window.
13. Click Exit to Hardware Setup: Prep Printers window.
14. Click Exit to exit the Hardware section of BOW.
15. Select Restaurant Misc Data.
16. Select XML I/O.
17. In XML Journal (TCP/IP), select the printer, created above, from the list.
18. Click the Expanded format? check box.
19. Click OK.
20. Click Exit to Restaurant Misc Data options.
21. Click Exit to Setup options
22. Select Immed System Change.
23. Click Exit to the BOW application.
Edit SPCWIN.INI
1. Open C:\DB\SPCWIN.INI
2. Use the following settings
[NETWORK]
TCP/IP=YES
Spcwin=
[VIRTUAL]
VirtualPath0X=
Note:
X is the Device Number of the printer created previously.
[XML]
ListenXMLServerPort=5015
ConnectXMLServerPort=5015