OpenEye SW-RWTCP - Manual (Page 19)

27314AI 19
DVR / NVR Server Side Setup
1. Click Setup on the Main Display screen of the DVR or NVR Software.
2. Click General in Setup.
3. Click the POS Setup button to open the POS Setup window.
4. Click the Setup POS Agent button in the POS Setup window to open the Communication Status window.
5. Set the Protocol to Micros 3700 V2 in the Communication Status window and click Setup.
6. In the Save tab select the Save Location and configure the other save options then click Apply.
7. Click the Communication tab and set the POS ID to the register number you are connecting to and the Type as TCP Server.
8. Click Add to open TCP/UDP Communication window.
9. In the TCP/UDP Communication window, enter the TCP\IP Port used above in step 3c of the Micros installation matching the
Workstation Port line.
10. Click OK
11. Repeat steps 8-10 until all registers have been added then click the Apply and OK button.
12. Click OK to close the Communications Status window.
13. In the POS Setup window select a camera under Channel and assign it a register under POS. Repeat until all registers have
been assigned to a camera.
14. Click OK to save the current setting and close the POS Setup window.
15. Click Exit in the Setup Menu to return to the Main Display. Incoming transaction data should now be displayed on cameras with
registers assigned to them.