OpenEye SW-RWTCP - Manual (Page 14)

14
CONNECTING TO MULTIPLE POS DEVICES
To connect a DVR or NVR to multiple POS system perform the following steps:
Network Connection
SWITCH POS REGISTERS DIGITAL RECORDER
1. Connect the DVR or NVR and the POS Systems to the same network.
2. Follow the instructions outlined in the Installation and Configuration chapter of this manual for each of the specific POS Systems.
RS-232 Connection
POS REGISTER(S) DIGITAL RE CORDER
1. Connect the DVR or NVR to the serial output of the POS System or Video Text Inserter using a serial cable and Y-cable if
necessary.
2. Repeat step one for remaining POS Systems or Video Text Inserters.
3. If all serial connection on the DVR or NVR are full, a Serial Expansion Card or Serial Virtualization Device may be required.
4. Follow the instructions outlined in the Installation and Configuration chapter of this manual for each of the specific POS Systems.