Introduction – Nortec GS Series User Manual
Page 5
GS Series Installation | 2
Introduction
CAUTION: Servicing
Nortec does not accept any liability for installations of humidity equipment installed by
unqualified personnel or the use of parts/components/equipment that are not authorized
or approved by Nortec.
Every person working with the Nortec GS Series must read and understand the
installation and operating instructions before carrying out any work.
Disconnect main power and shut off gas supply before any servicing.
During and following operation of the humidifier, the steam and components in contact
with the steam can become hot and burn if touched.
Poorly maintained humidifiers can endanger health of building occupants.
The GS must be serviced in the intervals described in the maintenance section of this
manual.
Be mindful of weather. Opening a GSTC Outdoor enclosure exposes internal components
that should not come into contact with water. It is not recommended to perform ay
service on an Outdoor GSTC during rain, snow, sleep or hail.
CAUTION: Electrical
All electrical work should be done according to local electrical code.
Electrical connection to be performed by a licensed electrician.
CAUTION: General
The Nortec GS series must be kept clear and free of combustible materials, gasoline, and
other flammable vapors and liquids.
The indoor GS humidifier located in an insulated space must be kept free and clear of
insulating material. Do not add combustible insulating material to the appliance.
The GS humidifier requires proper ducting for combustion air and exhaust ventilation for
safe operation. Avoid blocking or obstructing air openings on the appliance, air openings
communicating with the area in which the appliance is installed and the spacing around
the appliance.
Should overheating occur, or the gas supply fails to shutoff, shut off the manual gas valve
to the appliance before switching off the electrical supply.
Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system
and any gas control which has been under water.