MicroLinks VT300 - user manual User Manual

Page 61

Microscope Application Program http://www.ViTiny.com

Fig 5-69 Rectangle

(7) 3 Points Angle: Measure the angle on the object and use

. In Fig. 5-70, it

can see an angle on the object, draw a line and stop at the corner of angle, and

then draw the other line from the angle; the angle can be automatically calculated.

a dot shows the measured angle, it is 135.5

Fig 5-70 3 Points Angle

(8) 3 Points Fillet: Measure charm and use

. Draw first line on the angle (see

line A) and press the left mouse button to drag a line on the other side of the angle

(See line B) to calculate the chamfer. See Fig 5-71. There is a small dot

inside the chamfer and shows 45.8