MicroLinks VT300 - user manual - Manual (Page 32)

Microscope Application Program http://www.ViTiny.com
Copyright ©2008-2012 MicroLinks Technology Corp.
5 Mode Functions
When connecting the AP with VT300, the four mode functions will show up on the button
position under left sub-window. See Fig.5-1.
Fig 5-1 Modes Toolbar
 Comparison mode (refer to section 5.1) ：
Comparison mode can overlapping two frames. The frame can be whole or any size to compare.
This mode can see two frams of simiarities.
 Aiming mode (refer to section 5.2) ：
Provides a cross, area, rectangle and circular different aiming mode to aim the observation
object .That can help capture observation object.
 video control mode (refer to section 5.3) ：
The mode can control left hand or right hand to hold the machine, which can capture yourself or
objects, but the directions might not be correct. It can use the mode to adjust the dirctions and it
can adjust contrast, brightness and exposure.
 measurement mode (refer to section 5.4) ：
Measurement mode has ruler functions to measure at real time, which provides different
measurement tools.
5.1 Comparison mode
When connected, the defult of the toolbar is set as to compare shown in Fig.5-2 and Fig 5-3.
In Fig.1-6 right sub-window has no image so some part of the buttons wouldn‟t work in this
mode. Comparesion mode can be overlap with another video image to compare and to cut half of
the image for comparession.
Fig. 5-2 Comparison mode
Fig. 5-3 Comparison mode toolbar