Microcom LDSII - Manual (Page 79)

Chapter 4 Special Features
LDSII Programming Guide - 880015-0123 63
Figure 16 Line Draw Feature
Two Lines Example:
^A)
^D200) 3.3, 1.9, 0.125, 1.063, 5, 1
^F1) 1.0, 1.0, @line, 1.11, 0.01
^F1) 1.55,0.25,@line, 0.01, 0.75
^F1) 1.0, 1.0, @normal_14
^T1)Line Draw Feature
^D300)1
^Z)
Figure 17 Two Lines
This example shows a line inserted an inch from the left side and an inch from the bottom.
This line would be 0.0
1” in height and would be 1.11” in width or length. A second line is
being inserted 1.55” from the left edge and a .25” from the bottom. This line would be 0.75”
in height and would be 0.01” in width or length. This demonstrates that the Line Draw
feature can be used to draw any amount of lines desired without crea
ting a new “^Tn)”
pointer as seen in the example above.
Line Draw Feature
Line Draw Feature