Microcom LDSII User Manual
Page 45
Chapter 2
Printer Commands
LDSII Programming Guide - 880015-0123
29
Byte Mode
Responses
(ASCII)
Text / Verbose Mode Response Equivalent
0xDB
>I/O FAILURE<
0xDC
>FONT/GRAPHIC NOT FOUND<
0xDD
>BAD FILENAME<
0xE1
>SWITCH 0 ACTUATED<
0xE2
>SWITCH 1 ACTUATED<
0xE3
>SWITCH 2 ACTUATED<
0xE4
>TOF SWITCH ACTUATED<
0xF0
>FIELD OFF IMAGE<
0xF1
>COMPOSITION ERROR<
0XF2
>GRAPHIC TOO LARGE<
0xFF
>POWERED DOWN<
Table 6
^D365) Status Response List
2.3.21 ^D390)1
(Reset Printer)
This command instructs the printer to perform a reset through software, which duplicates a
hard reset. This command may be issued from either inside or outside a script file. Caution
should be used if issued from inside a script before sending data after a reset due to the
power up time. It is a good idea to issue an Enquiry command (
“^D327)1” or ^E) before
sending data after a reset to verify that the printer has returned to a >READY< status. The
“^D390)1” command is the queued equivalent to the immediate ^R (ASCII 0x12) control
code.
2.3.22 ^D391)1
(Restore Configuration Defaults)
This command is used to restore configuration defaults to a known state. This command
may be sent from inside or outside a script. If this command is sent inside a script file, the
printer will transiently restore factory defaults, with the exception of Model Type (
“^D501)”)
and Serial Port parameters (
“^D670)”), before executing any other command regardless of
the placement within the script file. This command should be sent to the printer outside a
script file as a part of a Flash memory update. Failure to issue the
“^D391)1” command
after a Flash code update may cause the printer to become unstable.
2.3.23 ^D392)1
(Restore Property Defaults)
This command is used to
restore the printer’s property command defaults to a known state.
This command may be sent from inside or outside a script. If this command is sent inside a
script file, the printer will transiently restore factory defaults. This command should be sent
to the printer outside a script file as a part of a Flash memory update. Failure to issue the