Microcom LDSII - Manual (Page 63)

Chapter 2 Printer Commands
LDSII Programming Guide - 880015-0123 47
2.6.9 ^D740)n (Enable Cutter)
This command is used to control the enablement of a cutter that has been selected using
the
“^D506)” command. If a cutter is not installed, selected, and this command is enabled,
the printer issues the
>CUTTER INOPERATIVE< or 0x11 depending on the “^D550)”
command configuration.
0 Disable
1 Enable
2.6.10 ^D741)n
(Enable PMH)
The “^D741)” command is used to control the enablement of a PMH (Printed Media
Handler) that has been selected using the
“^D507)” command.
0 Disable
1 Enable
2.6.11 ^D760)n
(Enable Auto Defrag on Power-up)
If this command is enabled, the printer automatically performs a flash memory defrag on a
power-up and/or reset when the flash memory falls below 10% of the total file area or if an
attempt to save a file larger than available flash occurs. The printer transfers or copies the
contents of flash memory to RAM and then performs the flash memory defrag on the next
power-cycle or reset condition. The RAM contents are then resaved into flash memory once
the memory defrag is completed. If power is cycled during a flash defrag, the contents of
flash will be lost and of corrupted. The printer responds with either >FLASH
DEFRAGMENTING< or 0x8A depending on the “^D550)” command configuration while
performing the flash memory defragmenting.
0 Disable
1 Enable
2.6.12 ^D770)n
(Enable Software Flow Control)
This command determines if software flow control (XON / XOFF) will be used to throttle the
printer’s response between the host and the printer.
0 Disable
1 Enable
2.6.13 ^D771)n
(Enable Hardware Flow Control)
This command determines if hardware flow control (CTS / RTS) will be used to throttle the
printer’s responses between the host and the printer.
0 Disable
1 Enable