Microcom LDSII User Manual
Page 67
Chapter 2
Printer Commands
LDSII Programming Guide - 880015-0123
51
2. Load media into the printer.
3. Establish communication with a terminal emulation program (HyperTerminal, Tera Term
Pro, etc.).
4.
Be sure that the printer is in a transmissive detection mode (“2” or “3”) by issuing the
“^D636)?” command.
5. Enter Tic mode [^D900)f,3].
6. The printer will return a numerical value for the Gap Sensor output.
7. A high value should be returned for the area outside of the black line. A low value
should be returned when the black line passes over the black line.
8. Enter a new threshold value (between the high value and the low value) using the Gap
Sensor Threshold command [^D680)n]
Figure 11
^D900 Die-cut Listing
Label sensed
(Beginning)
Label sensed
(Beginning)
Threshold is “crossover point”
between [label backing] and
[label backing + label].
Threshold will be a value
between upper value and
lower average value.
Gap Threshold Setting
– 30
(Factory Setting)
Values being
reported from
the registration
mark sensors