Microcom LDSII - Manual (Page 58)

Printer Commands Chapter 2
42 LDSII Programming Guide - 880015-0123
Printer Model
Number
Recommended
^D648 Value
226
2.32”
326M 1.36”
426M 1.36”
426
2.32”
Table 8 Blackline Sensor to Print Head Distance
2.5.19 ^D649)n
(Set Gap Sensor to Print Head Distance)
The
“^D649)” command is used to set the gap sensor to print head distance at the factory.
This c ommand is a “property” which means that it controls a specific distance that is set at
the factory. The property commands may be set back to their default values using the
“^D392)1” command.
Printer Model
Number
Recommended
^D649 Value
226
2.34”
326M 1.38”
426M
1.38”
426
2.34”
Table 9 Gap Sensor to Print Head Distance
2.5.20 ^D655)n
(Set Labels Printed)
This command gives the user the ability to set and/or reset the “Labels Printed” counter of
the printer that is reported either by issuing the
“^D655)” without a parameter or “^D324)”
(List Statistics) command.
2.5.21 ^D670)
(Set Serial Port)
The
“^D670)” command is used to configure the serial port. The command starts with the
“^D670)” and is then followed by four parameters or arguments. The first parameter must
be separated from the ^D command by a space and the following parameters must be
separated from each other using the comma delimiter. The command is entered using